Jerry's Plumbing Inc

(3 Reviews)
6250 Bunker Lake Blvd #222, Ramsey, MN 55303, USA

Jerry's Plumbing Inc is located in Anoka County of Minnesota state. On the street of Bunker Lake Boulevard and street number is 6250. To communicate or ask something with the place, the Phone number is (763) 252-4268.
The coordinates that you can use in navigation applications to get to find Jerry's Plumbing Inc quickly are 45.2208733 ,-93.410213

Contact and Address

Address: 6250 Bunker Lake Blvd #222, Ramsey, MN 55303, USA
Postal code: 55303
Phone: (763) 252-4268

Location & routing

Get Directions

Reviews

  • Rodger Carey

    (August 6, 2020, 9:34 pm)

    This is not Jerrys anymore, it is now Superior. We loved Jerrys but thought we would try them. The good: they came out within the hour. The job was very satisfactory. It was exactly as quoted, they are definitely more expensive than Jerry’s. The bad: the installer came in without a mask. Not a good idea during a pandemic. They should not be putting others at risk.

  • Dan Harbinson

    (May 14, 2019, 9:26 am)

    I had Jerry's Plumbing out again to do some more work in our home. Chad was on time, did a professional job, and cleaned up very nicely. I thought the price was very reasonable and came in $20 under the ball-park estimate they had provided on the phone. They will continue to be my first call when I need plumbing work done.

  • Jeff S

    (April 8, 2013, 4:42 pm)

    I self-installed a new water heater over the weekend only to end up with low hot water pressure. The issue turned out to be over soldering when installing the union on the cold water inlet--solder had dropped down the pipe and solidified in the nipple causing a obstruction. He identified the location of the issue immediately, by turning off and on the cold water valve and noticing no change in sound, i.e. no change in water pressure. He said with new water heater installs he usually recommends replacing the valve as well, which we had not done. After taking the cold water inlet apart the source of the pressure issue was identified. He replaced the nipple, installed a new valve, and the replaced the pipe between the two. It took about 40 minutes.

Write a Review